Yes then no again !! manually entered sats for 119 and had them on for a few days , now 119 gone . Today I tried to do this again , but all sats in 119 dish pointing menu lock on to 110 on the top of the screen
Yes then no again !! manually entered sats for 119 and had them on for a few days , now 119 gone . Today I tried to do this again , but all sats in 119 dish pointing menu lock on to 110 on the top of the screen
Then the switch is going bad or the tuner is going bad or the receiver don't have enough azz to switch sats.
BTW, what jynx do you have.
Last edited by iq180; 07-20-2015 at 09:52 PM.
I manually added a sat for 119 and got the channels for a few days , then back the same . 110 ok , but no signal for 119 . tried to manually add again , but sats lock onto 110 as seen at top of page for "dish setting" . I go to 119 sat and can't get a signal for 119 , but I do get 110 . Is this my splitter switch ?
Jynx V2 HD . Sorry , you answer didn't pop up for me until I gave another response . I have bought another JB200 , but I think I might change the switch first . Stay tuned (joke)
Got around to replacing the switch , but same problem . Will try JB200 next
ALL information contained herein is for educational and informational purposes only.
Any information contained herein is public knowledge and reposted as such. I take no responsibility for any misuse of any information contained.
OK thanks ... gonna stay in from the heat and give it a try . Let you know how I make out
EUREKA !!! Had this V2 for at least 5 years , never lost JB200 signals until recently . What a relief ! Thanks to all for your help . Tuner was easy to install, 5 philips screws and 2 nuts on co-ax threads . Saw this on the site . What a great site this is