hi, After a few little problems upgrading the ilink 9800hd se receiver, I installed the 2 latest files & the same no signal
issues continue, the files are: v333, v338.
hi, After a few little problems upgrading the ilink 9800hd se receiver, I installed the 2 latest files & the same no signal
issues continue, the files are: v333, v338.
friend try posting the settings for each sat your pointing too,and if your using a switch post what kind your using....
Yes your problem could be in your anntena settings..
Like SC suggested post your settings so we can help you better..and what type of lnb you are using..
hi & thank-you! I am using a 4x1 diseqc switch with legacy lnb, I have used this setting for all my fta receivers
no problems at all, all channels come in fine, when I turn the unit off and next day turn it back on! no signal
sign is all I get, then I press menu and go to the satellite menu were no signals show for diseqc 1,2,or 3.
friend I think I know what your talking about,i had the same problem with the legacy lnbs,sometimes in the evening and mornings, it would show some channels with no signal at all,not sure how I fix it,but try doing a factory default on your receiver and then re-enter the settings for each sat and scan for channels or try re-aiming the dish,can,t remember how I fix mine but its one of this steps,good luck friend....
Last edited by steven charles; 10-27-2014 at 10:28 PM.