Hey everyone ,
Im not using Bev anymore and my guide is still showing most of Bevs channels on my 119 sat
Is there any way to cancel out all the Bev channels ?
Thanks
Hey everyone ,
Im not using Bev anymore and my guide is still showing most of Bevs channels on my 119 sat
Is there any way to cancel out all the Bev channels ?
Thanks
select a bev channel... go into channel manager....rename should be highlighted... using your arrows on remote scroll over to delete.... it will default to ch del... hit the yellow button(del option) on remote twice so it reads sat del... a bev sat should already be highlighted so you can hit the blue button on remote & delete it...
Factory reset and rescan, probably time you did as channels are moved and transponders are updated from time
to time.
If you are showing bev channels on 119 then your antenna settings and or dish is a little off. When in 119 antenna settings you must have a lock on satellite. That is usually confirmed by 119 being shown at top of page. If it says 91 then that's where the dish is aimed.
Yes just make sure that you reset network off of Dream!!
Factory default will erase your sat info and any switch info only, simply factory set, rescan each sat you had previously.Your switch settings should match the sat you choose,(see post #6) the correct sat will appear to match the sat selected with good signal. Any issues, come on back for some help.
Last edited by Hunter11; 11-11-2014 at 02:18 AM. Reason: refer to post #6
the nano premium will not dump the network info however it will default to nano stream so be sure to reset it to dream after default
Ok it worked , bev channels are gone ..
Now it wont let me scan in the 119.
the 110 scanned in , I tried two different switches now , ive never had an issue with 119 before ...
info
Sat ; echo 14ku
diseqc; 3
diseqc 1.1 ; none
tp frequency ; 12297
lnb; 11250
22khz ; off
multi disc switch ; off
search options ; all channels
lnb power ; on
info
Sat ; echo 10/11
diseqc; 1
diseqc 1.1 ; none
tp frequency ; 12224
lnb; 11250
22khz ; off
multi disc switch ; off
search options ; all channels
lnb power on
try bypassing the switch & run the 119 direct to the receiver... If it still doesn't come in you have a bad cable or connector or an LNB thats gone south if you'll excuse the pun or the dish is out of alignment
Double check your settings particularly your diseqc port, are you seeing the banner for your sat in that screen with good signal and quality?
Last edited by Hunter11; 11-15-2014 at 06:19 AM.