Originally Posted by
chs1982
I have a Jynxbox Ultra HD v2 with a Dish 500 w/ Dish Pro Plus Twin LNB. I installed the 2.37 firmware and did hard boot, I scanned for channels and was even able to watch tv last night. A few questions, I tried to put the network info info in slot 1, everything was copied over from my working Nano2, port 15010 but it kept saying connection failed when I hit apply. But I was able to watch cable yesterday so not sure what the problem was.
That being said, when changing through the channels the remote would just freeze up with a black screen and the buttons would not work, the red light indicator would still flash when I hit a button but only way out of it was by doing a hard reset from the back. Is this happening because of the server settings? Or is do I not have enough power with my setup to the lnb's? Everything was working good on the Nano2, thanks for your help in advance.