PDA

View Full Version : sv 8000 no signal



dues
09-22-2013, 04:05 PM
When I reboot my receiver I get no signal. I have to factory reset and set up all the sat again . Then it works until I reboot it.

junior1
09-22-2013, 04:17 PM
I suggest you check your coaxial cables and your coaxial jumper going to your HD module.

dues
09-22-2013, 08:30 PM
I suggest you check your coaxial cables and your coaxial jumper going to your HD module.

I checked all connection even by pass swicht and try all sat one by one still the same. Could it be software or power supply?

bart42
09-22-2013, 11:50 PM
When I change servers sometimes the receiver reboots and most of the time I also loose signal.I just reboot from rear switch waiting 30 sec. and when it reboots signal returns if I wait a moment.

tinman948
09-23-2013, 12:43 AM
The problem with changing servers and rebooting seems to be a bug with the sv8k. Mine will usually freeze when I change servers.
Some say that having it on channel 100 before you change servers helps but I never seen any difference.

It's Jafo
09-23-2013, 09:53 AM
This is a known issue with the 8k file.
Some revert back to Ihub and run the 514 file to get around the problem.
There is currently no other fix.

:)

dues
09-29-2013, 10:05 PM
Does anyone have info on how to replace bad cap. The one here want to change all of them