PDA

View Full Version : "secu fail" on display



kylo
10-25-2012, 03:20 PM
I hadn't used my hd8000 for about a month and went to fire it up and it stayed in booting for a while, went to start up and "secu fail" showed on the display. Tried to reload with thumb-drive but didn't go into load from usb. Tried my null modem cable with no luck. Any ideas? Is "secu fail"= security fail?

junior1
10-25-2012, 03:55 PM
I think you posted this at another site. Try disconnecting your satellite cable and do a hard reboot.

kylo
10-25-2012, 04:18 PM
Tried it, no good. I removed the 8psk board, same problem. I checked voltages on power supply and all were right on spec except -30 is showing as -26.9. This might be where the problem is.